Spare Parts
We stock a range of spare parts for…
The VHT12 is easy to install to small boats and RV's / caravans
Comes with:
Available in 12 volts
Vacuum pump pre-wire
Wiring loom and control panel
Discharge pump
Odour Filter
Easy connection to toilet. Can be installed up to 20 feet (6.1 meters) from the toilet using 1-1/2 (38mm) sanitation hose.
VacuFlush systems use a small amount of water (one pint to one quart) and the vacuum that is generated by the vacuum pump to flush. Each toilet must be connected to a pressurised water system. Fresh water is recommended and will result in an odour-free bathroom.
If seawater is used, the water should be filtered.
No complicated user instructions are required. Lifting the flush lever adds water to the bowl. Pressing the flush lever (or pulling the flush lever on a 106 toilet) opens a mechanical seal that allows the vacuum force to pull the waste from the bowl as clean water rinses the bowl. The vacuum moves the waste (at approximately 7 feet [2.1 m] per second) through a one-inch opening in the toilet base.
Incoming air fragments the waste as it passes through the base opening. This process eliminates the need for macerators or mechanical motors in the toilet base.
Next, the waste is transferred into the Vacuum Holding Tank (VHT). System vacuum is monitored by a vacuum switch that is located on the outside of the VHT. When the switch senses a drop in vacuum in the system, it automatically signals the pump to energize and bring the
vacuum back to operating level. This process is normally completed in about one minute. In a properly operating system, the stored vacuum will
“leak” down between flushes, causing the vacuum pump to run for a short period. The pump should not run more than once every three (3) hours after the last flush.
An “On-Off” night switch can be installed to silence the vacuum pump during sleeping hours. The VacuFlush Status Panel, an optional accessory, features an integral circuit breaker that provides a convenient night switch.
Marine Sanitation PTY LTD would like to introduce the new look Marsan Odour Filter.
The Marsan Odour Filter is designed to eliminate any bad odours from both black and grey water waste tanks.
Key Benefits:
100% compatible with all waste tanks
Used for Marine, Recreational Vehicle / Caravans
4 sizes to suit hoses 5/8″(16mm), 3/4″(19mm), 1″(25mm) and 1-1/2″(38mm)
Comes with quick release brackets for easy replacement
Granulated charcoal filter which keeps the air smelling fresh
Made in Australia
The Marsan Odour Filter can be purchased from most RV shops and boat chandleries.
Dometic Duckbill Valve are used in Dometic vacuum and discharge pumps to stop vacuum leaks and waste back flow.
Clean ‘n Green cleans marine toilets and controls holding tank odours.
Clean any marine toilet, freshen the air, and control holding tank odours with this 3-in-1 toilet system product.
Each pre-measured toss-in tabs effervesces on contact with the bowl water to begin cleaning. Bubbling action also releases a pleasant fragrance. After cleaning, natural enzymes help deodorise the holding tank.
Cleans any marine or RV toilet with one treatment
Won't harm plastic bowls or rubber seals
Non-Toxic, non-staining formula contains 100% biodegradable granules
Enzymes break down waste and toilet tissue for thorough tank discharge
12 tabs per container
Spare cassette waste tank suit the Dometic swivel, ceramic bowl, toilet.
Suit CTS-3110.